Hot air Reflow Soldering Oven 12 zones
HB Automation Advantages
HB Automation is a comprehensive supplier in the SMT market to provide our customer with a wide range of the most innovative and reliable types of SMT equipment including Reflow oven with 12 zones model, with thermal accuracy of ±1˚C, produces a ΔT of ±2°C across. PCB assemblies to 610 mm wide with a throughput that can keep pace with high-volume production. We are expecting to become your long-term partner in China
Number of heating zones
Top 10+ bottom 10
Length of heating zones(mm)
Number of cooling zones
Top 2 Forced air cooling
10M2/min *2 channel exhaust
Power supply requirements
3 phase, 380V 50/60Hz ( optional: 3 phase, 220V 50/60V)
Normal Power consumption
Temp. setting range
Room temperature to 300°C
Temperature control method
PID Close loop control +SSR Driving
Temperature control precision
+/- 1.0 °C
Temperature deviation on PCB
+/- 1.5°C ( by HB test standard )
Single buckle for preventing board jammed
Max. PCB width
400mm ( Optional 610mm )
Range of rail width
50mm -400mm (optional 50mm -610mm )
Top/Bottom clearance of PCB : 25mm
L to R ( Optional R to L )
PCB transmission method
Chain + Mesh
300mm /min-2000mm / min
Auto-lubrication + Manual-lubrication
• 12 zones model CS-1202
• 5 years for the heaters, blowers and solder pot - 2 on all other parts.
• Automatic edge rail lubrication system
• Board counter
• Board drop detection
• UPS power supply equipped
• Dual lane conveyor with independent speed control( Optional)
• Power savings of 15 to 20 %, due to large aluminum alloy heat plates.
• Double insulation around the body prevents heat loss
• Short warm-up time
• Low power consumption:
• New and improved highly effective exhaust design with piping in each zone to extract flux.
Q: What is the standard warranty for HB Automation's machine?
A: HB Automation provides 5 years warranty for the heaters and motors in the reflow oven and wave soldering machine and all the other any parts are available to enjoy 2 years warranty.
Q: Things to Know
A: When dealing with reflow soldering there are some things to know which usually are not needed when hand soldering with an iron.
The first is that some components are sensible to thermal chock and the moisture content of their packages may be an issue.
When you order some big microcontroller from Digi-Key or Mouser they usually come in a sealed bag with a humidity indicator and a desiccant pack inside. That's because the moisture in the package when exposed to high temperatures vaporizes and, if you do not give this vapors enough time to exit the package, the result could be a cracked microcontroller.